#ROBOTC EV3 FULL#

into port 2 to -2000 degrees at a speed of -75Р”Р‡loat getMotorTarget ( tMotor nMotorIndex )Р”Р‡unctions returns a floating point decimal value. Sets the absolute position target of the motor plugged into motor port A to 1000 degrees at a speed of 50 The resetMotorEncoder(nMotorIndex) command should be used before a moveMotorTarget(nMotorIndex) to ensure the motor is turning in the correct direction.Р”В¬ode Example: //Sets the absolute position target of the motor plugged.nPosition takes values in degrees (unless the encoder units are set to a different mode using the setMotorEncoderUnits command.The set distance to travel specified by nPosition. The port the motor (in servo mode) is plugged into to nMotorIndex. This command needs three pieces of information. This command tells the robot to move an absolute distance.SetMotorTarget(nMotorIndex, nPosition, nSpeed) Target absolute value that the motor will travel to. Void setMotorTarget ( tMotor nMotorIndex, float nPosition, int nspeed ) Moves the motor on motorA -1000 encoder counts (backwards) At the end of this command, the motor will automatically come to a stop.Р”В¬ode Example: //Moves the motor on motor port A 1000 degrees (forward).

Setting either the target or the speed to a negative number will cause the motor to rotate backwards.

The third item is the velocity, which is designated by the nSpeed command.

The amount of degrees (incremental), which is designated by nPosition command.

The motor, which is designated by the nMotorIndex command.

The command needs three pieces of information:

It will add (or subtract) distance from any previously specified targets.

This command tells the robot to move a relative distance.

MoveMoterTarget(nMotorIndex, nPosition, nSpeed) Speed value that will be passed to the motor (-100 to +100). Target incremental value that the motor will travel to. Void moveMotorTarget ( tMotor nMotorIndex ) Holds program flow until the motor on motor port A comes to a complete stop.

You can use this command to avoid providing a wait time.Р”В¬ode Example: //Sets the motorA's target to 1000 encoder counts at a speed value of 50.

This command will 'sleep' your program until the specified motor (nMotorIndex) comes to a stop.

Sets the speed value of motor motor port A to stopped (0)Р”В«ool waitUntilMotorStop ( tMotor nMotorIndex ) Sets the speed value of motor motor port A to half-speed backwards (-50)

Halt program flow for 1000ms (1 second)

#ROBOTC EV3 FULL#

A zero value stops the motor.Р”В¬ode Example: //Sets the speed value of motor motor port A to full forward (+100) Values for the motor velocity range from -100 (full reverse) to +100 (full forward).The nMotorIndex command identifies the name or port of the motor.The velocity for the motor, which the nSpeed command is used for, and the port that the motor is plugged into. There are two pieces of information that this command needs.This command will set the speed of the motor.Zero is the value for stopping the motors Port number that the motor is plugged into. Void setMotorSpeed ( tMotor nMotorIndex, int nSpeed ) A count of 180 indicates that the motor has traveled half of a rotation. The encoders have 360 counts per single revolution of the motor. Each motor is equipped with an integrated encoder that can be used to determine the current position of the motor. There are four motor ports on the EV3 labeled A, B, C, and D. Our Function Library (Updated Spring 2013) EV3 - Motor Commands A Non-Functioning EV3 (i.e., frozen or dead).

Robotc ev3